Setting up a Brick Paver Walkway or Brick Making Plant

The usage of Bricks or Pavers to create a sidewalk or outdoor patio matches a house in a method that is unrivaled. In addition, setting up a Brick or Paver walkway does not always require a pro.

The secret to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. The location needs to be dug out a minimum of a foot down, eliminating all topsoil and clay soil. In addition, string lines should be strung on each side of the walkway. The string lines suggest the finished height of the sidewalk.
As soon as the area has been dug, 3/4" gravel stone need to be laid in and tamped down firmly. 2" of sand, or stone dust must be spread out over the gravel. Once again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline should equal the density of the brick or paver.

Now that you have a stable base, place a 1" pipeline or journal board the length of the walkway on either side of the sidewalk. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your sidewalk border and assistance to preserve the integrity and shape of the sidewalk.

The secret to laying the bricks/pavers is to make sure that they interlock with each other. Always stagger brick making plant surrounding rows of bricks by 1/2 of a brick to interlock them. This will again help maintain the integrity of the sidewalk.

Undoubtedly bricks/pavers will need to be cut or split when constructing the walkway. Unless you wish to buy or lease a pricey wetsaw, I would recommend buying an easy brick/paver splitter. It is basically a chisel with a broad end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you desire to break more info the brick. Then using a hammer strike the butt end of the sculpt strongly. You might need to do this a number of times. You may also desire to flip the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within one or 2 strikes the brick/paver must break cleanly. If your sidewalk has curves you will need to buy/rent a wetsaw.

After installing the bricks, build up the outside edges with extra sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the brand-new walkway and sweep into the cracks. This will finish the interlocking of the bricks and assist to eliminate any weed growth.


In addition, setting up a Brick or Paver walkway does not necessarily need a pro. The secret to setting up a Brick or Paver Walkway is to very first effectively prepare the area where the bricks/pavers are to be set up. Now that you have a steady base, position a 1" pipeline or ledger board the length of the pathway on either side of the walkway. These strips will act as your pathway border and assistance to maintain the stability and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when constructing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *